| Juniper Commands |
Function |
| show version |
Display the system hardware config., software version, and name and source of configuration files and boot images. |
| show chassis hardware |
Displays power-on diagnostics status. |
| show chassis environment |
Displays temperature and voltage information on the console. |
| show configuration |
Display All configurations inside the router. |
| show system virtual-memory |
Display the usage of JUNOS kernel memory, listed first by size of allocation and then by type of usage. Use show system virtual-memory for troubleshooting with JTAC. |
| show interface |
Displays the status of interfaces configured for IP. |
| show interfaces detail |
Displays the interface configuration, status and statistics. |
| show interfaces extensive |
Displays information about a physical port device. |
| show interfaces description |
Displays the interface configuration, status and statistics. |
| show route |
Displays summary information about entries in the routing table. |
| show system process |
Displays utilization statistics. |
| show system uptime |
Display the system hardware config , software version, and name and source of configuration files and boot images. |
| show log messages |
Display the state of logging to the syslog. |
| show policy name |
Display all route-maps configured or only the one specified. |
| show log user |
Display users who are viewing the system log. |
| show system alarms |
Display active system alarms. |
| show system audit
|
Display the state and checksum values for file systems. |
| show system boot-messages |
Display initial messages generated by the system kernel upon startup. These messages are the contents of /var/run/dmesg.boot. |
| show system core-dumps |
Display a core file generated by an internal JUNOS process. |
| sshow system directory-usage
|
Display directory usage information. |
| show system reboot |
Display pending system reboots or halts. |
| show system snapshot |
Display information about the backup software that is located in the /altroot and /altconfig file systems. To back up software, use the request system snapshot command. |
| show system software |
Display the JUNOS extensions loaded on your switch. |
| show system statistics |
Display systemwide protocol-related statistics. |
| show system storage |
Display statistics about the amount of free disk space in the switch's file systems. |
| show system users
|
Show all users who are currently logged in. |
| show system buffers |
Display information about the buffer pool that the Routing Engine uses for local traffic. Local traffic is the routing and management traffic that is exchanged between the Routing Engine and the Packet Forwarding Engine within the switch, as well as the routing and management traffic from IP (that is, from OSPF, BGP, SNMP, ping operations, and so on). |
| show system connections |
Display information about the active IP sockets on the Routing Engine. Use this command to verify which servers are active on a system and which connections are currently in progress. |
| show system processes |
Display information about software processes that are running on the switch and that have controlling terminals. |
| Set Date |
Set Date and Time. |
| show chassis firmware |
|
|
More list Protocols CLI Commands
|
|